The 1964 Nickel can be considered to be very interesting for collectors because there are several mistakes that can make the value of the coin much higher. However, the standard 1964 nickel does not usually sell for more than face value, the presence of these errors gives some coins extreme collector value, often more than $10.
Knowledge of these mistakes allows collectors to check if they possess an absolutely unique and valuable item.
This is a 1964 nickel though it has a doubled die on the front side; electr Pony
A doubled die obverse is one of the most common types of errors and many coin collectors desire it. This is caused by a die being struck twice while producing the coin and the features on the front side of the coin are visibly doubled up.
The doubling on a 1964 nickel is done in areas such as the date, lettering, and on the face of Jefferson’s image. But if you see this screw up, then the coin may be worth a lot more than $10.
1964 Nickel with Full Steps
A full steps designation regards the cues and comprehensivenesses of the steps on the back of the nickel especially those on Monticello. This aspect usually falls by the wayside in the minting process, and it is very difficult to find a coin where all the steps are clearly visible.
The full steps 1964 nickel depending on the state of the coin and the clarity of the steps to clients may be more than $10 if the coin has not been circulated.
A 1964 Nickel with Misaligned Die
A misaligned die error signifies a situation whereby the obverse or reverse die of a coin does not strike properly and thus an off center image is produced.
This can deem a 1964 nickel a completely different look because the image and/or text might be shifted which makes it valuable for collectors. Some coins with a misalignment over a hundred percent can sell at prices more than $10.
It is intensely fascinating the 1964 Nickel with Clipped Planchet.
A clipped planchet error occurs when the planchet from which the coin is made is not fully cut from the metal sheet, and in the process some part of the planchet is missing. This error can be defined as anything from a small chip right up though to huge sections missing, with more obscene pieces being much rarer and thus of course much more highly prized.
A 1964 nickel clipped on the planchet can be sold for over $10 if the clip is large and the coin is well circulated.
1964 Nickel with Die Cracks
The die cracks are the another error which can increase the value of the 1964 nickel. These are attributable to die defects or wear and tear when the tool used to strike the raw coin develops lines or cracks on its surface.
If the die crack is relatively small and situated at a less visible area of the coin then the value of the coin rises dramatically. Some of the die cracks can be seen clearly on a coin and this makes collectors to spend a lot of money above $10 to get such coins.
| Coin Name | Scarcity | Value | Unique Features |
|---|---|---|---|
| Doubled Die Obverse | Rare | Over $10 | Doubled design on date or letters |
| Full Steps | Rare | Over $10 | Full detail on Monticello steps |
| Misaligned Die | Rare | Over $10 | Off-center strike |
| Clipped Planchet | Rare | Over $10 | Missing part of the coin’s edge |
| Die Cracks | Rare | Over $10 | Visible cracks from die damage |
FAQs
Q. Why is the 1964 nickel special?
A. It is preferred if your 1964 nickel has specific mistakes such as a doubled die, full steps, misaligned die, clipped planchet or die cracks. These are usually minor mistakes and are actually the key contributing factor to why the coin is highly sought after by collectors.
Q. How can I tell a 1964 US nickel with full steps?
A. To learn full steps on a 1964 nickel, study the steps on the back at Monticello. Yes, if the above steps are in evidence and why they are not blended there must be a traces of full steps designation and the higher the value of the coin.
Q. Do all nickels minted in 1964 have a value greater than its face value?
A. Well, most of the 1964 nickels are worth Face value as long as they do not have the errors as described in this article. These particular mistakes on coins can actually be worth more than ten dollars.
Q. What are the signs of identifying misaligned die defect?
A. A misaligned die error occurs if the design at one side of a coin is slightly off center, where the design or inscription slides to one particular side on the die. This mistake can make these coins to become very pleasing to the collectors.
Q. When I discovered a rare 1964 nickel error what should I do?
A. If a coin collector thinks they have an error coin of 1964 nickel they should contact a coin dealer or grading service for an appraisal of the coin.